AMERICAN MASTER & WHEEL CYLINDERS
Buick - Cadillac/LaSalle - Chevrolet (Chevy) - Corvette - Camaro - Chrysler - Dodge/DeSoto - Ford - Mustang - Thunderbird - Lincoln/Mercury - Oldsmobile - Packard - Plymouth - Pontiac - Studebaker
Send us empty casting (all fittings, bleeders, etc. removed) and we will clean it, resleeve with brass to standard size and return, so you can reassemble using kit you provide.
MASTER AND WHEEL CYLINDERS
Master cylinder, single circuit, w remote reservoir (many pre-1930)(threaded end cap type $165)
Master cylinder, "in a box", with rotating arm on the side (some pre-1930)
Master cylinder, single circuit, cylinder and its reservoir cast as one piece (most 1930-1966) most
Master cylinder, dual circuit (most 1967 & later)
Master cylinder, 1956 Buick,(seal repair kit $75)
Wheel cylinder, straight bore
Wheel cylinder, step bore
Treadlevac power brake units, 1952-60 Bendix and Delco-Moraine (add $50 if new main shaft is needed)
Bendix Hydrovac power brake unit, 1950s Cadillac and other passenger cars, most units
Send us complete cylinder (as it came off the car) and we will return it cleaned, brass sleeved and assembled with new rebuild kit, ready to install back on the car.
Prices listed above are for 1 1/8 inch or smaller bore sizes (modest additional charge on larger cylinders) 631-369-9515 Mon - Fri 8:30 AM - 4:00 PM EST or email firstname.lastname@example.org
Part #: 1700-1799 Single arm, front and rear, screw on end caps, part # stamped there. Buick, Chevrolet, Chrysler, Crosley, DeSoto, Dodge, G.M.C Truck, Graham, International, Plymouth, Pontiac, Studebaker, Yellow.
*We do not carry this item in stock - We will Re-build and return your shocks. To place order, call: (631) 369-9515 or Email Info@applehydraulics.com